G3 Android 2.3.6 Gingerbread
Stockrom for Wynncom
Download the Android ADB USB Drivers for Wynncom devices from http://www.mediafire.com/download/hefa8w65op9u4qu/Adb-Driver-Installer.zip.
Switch off your device now and then remove its battery completely.
Leave the battery unplugged until the installation of the new stock ROM is complete.
Download the stock ROM zip for your device from the Devices panel at the end of this post.
Extract the Stock ROM contents on your computer.
Launch the ‘flash_tool.exe’ on your computer now.
After the SP Flash Tool is opened you need to click on the ‘Scatter-Loading’ button.
Locate the firmware ‘scatter’ file on your PC and then load it in the SP Flash Tool window.
Click the ‘Download’ button, it will start the installation.
Now you can connect your device to your PC via USB Cable.
Press Volume Up or Volume Down until your device is detected by your PC.
The Wynncom Android Stock ROM installation will continue now and you should see a green ring appearing when the install is complete.
Disconnect the device from PC, close the SP Flash Tool and then plug the device’s battery back into its original place. Reboot device and you’re done.